Toner molding machine and rod machine are charcoal equipment in the equipment, are the production of charcoal, toner molding machine and bar machine What is the difference? What's the difference? This is a lot of investment charcoal industry investors are concerned about the issue.

Toner molding machine is raw materials for carbonation, and then crushed, and then directly use the molding machine, by the carbon powder molding machine to suppress the carbon block, is the finished carbon. And the production of rods need to crush the raw materials, and then crushed the raw materials for drying, drying and then by the rod system rods in the rod machine to complete the rod, are semi-finished products, is the need for carbonization furnace After carbonization is the finished product.

Toner molding machine and rod machine are all pressed into the molding of raw materials, a pressing is finished, a pressed semi-finished products. The most used or rod machine, rod machine first crushing process, you can use the raw material than the toner molding machine to more, such as straw, straw, which can be first crushed, and then dried, rod, and carbon Powder molding machine can not be used. But many investors will ask, the toner machine is not necessary to buy, tell investors, the purchase of a toner molding machine is also very necessary, carbonization machine can be carbonized unqualified, and produce Broken carbon, the second reasonable use, they will be pressed, made of carbon stick. If there is no toner molding machine, unqualified carbon and broken carbon will be wasted, causing losses to the enterprise.