Key Points for Test of Briquette Press Ball Machine

 The newly purchased briquette press ball machine and other machines can be installed and manufactured if there are no problems with the selected manufacturer and the quality of the machine. Some users may have done trial production experiments in advance in the manufacturer, which is better. If not, it doesn't matter. After installation, we have to carry out a trial run to see whether the machine status and installation work are in place. Gongyi Hongrun Machinery Equipment Co., Ltd. is a professional manufacturer of ball pressing machines, providing users with a complete set of ball pressing machine production line design, planning, production and installation work. Here, we will explain some key points in the trial operation.

 

1. The relevant installation and preparation work must be done well before the test. Not to mention that everything is ready, we should also make sure that there are no mistakes. It can't run on the production line. Some preparations are not well done. For example, the preparation of materials to be pressed into balls. In particular, coal powder also needs water and adhesives. Therefore, it is very important to plan and sort out the machine installation and material preparation in advance.

 

2. After the preparation for the installation of the whole briquetting machine. After starting the machine, be sure to idle for a few minutes before feeding. The significance of this process is to preheat the running-in of the machine. And problems can be repaired and solved in time. In order to avoid the trouble and inconvenience of finding problems to solve after feeding production.

 

3. After no problems or faults occur during idling time, it can be put into production. Strip production test machine is an excellent testing method. It should be emphasized that it is not possible to feed directly and then start the briquetting machine and other equipment. This will cause enormous load, and may cause burnout of the motor and so on.